Features

• Bore range: up to 79.3mm
• Nom. Transmitting Torque: 1400Nm
• shaft mounted and supplied pre-lubricated with special purpose grease
• The shaft must be supported by two bearings for proper operation
• It is particularly suited to gear units and other equipment requiring precise concentricity between the shaft and housing
• The shaft must be carburised to an effective case depth of 1.2–1.5 mm and ground accordingly
• Surface hardness should be 60 HRC with a surface finish of Ra 0.3–0.5 μm, and taper must not exceed 8 μm per 25.4 mm
• Shaft and housing concentricity must be maintained within 0.05 mm TIR using appropriate bearing support.